With cutting plywood, it also helps a lot to have an air assist, which blows all the smoke out of the cut. That isn’t strictly necessary, but just helps to make sure it cuts through everywhere. I am also stepping down 1mm in between the passes, to move the focus point down a bit. I found that I can get through in just one pass if I slow it down enough, but the cut comes out cleaner if I do two faster passes. The setting I’m using to cut 4mm plywood on my 10W laser is 170mm/min with two passes. Luckily it worked out quite well, and in the end the proportions ended up looking good. When scaling I had to pay attention, that the slot, where the two pieces mate together, is the right size for the plywood I’m using. I also had to scale it, so that they would have the right proportions for the board. I found the design for the pieces online, though it did need some fixing, as some of the figures were not quite straight. That works out great, as the edge will be black due to the cutting anyways. For the white figures, I left them in the wood color, while on the black ones, I just spray-painted the plywood black before cutting. They are cut out of 4mm plywood and then glued together from two pieces to create a 3d figure. Now everything that was missing were the chess pieces to play with. 3D Camera with full control, with cutscenes during kills, activations etc.In a recent video I made a chessboard out of some white oak.Many different pieces with advantages, downsides, abilities and more.A lot of scenarios/maps designed to challenge you, some having unique pieces only available in them. All games can also be played in Competitive/Timed Mode!.[Replay mode (go through and analyze the moves and laser shots you and your opponent made after a game.
0 Comments
Leave a Reply. |